Free shipping · 2-year warranty · 14-day right of withdrawal, also in SwitzerlandFree shipping · 2-year warranty

Instructions, Tips & Tricks

Before you start ...

  • Don't worry - it's easy to set up
  • Stay creative - none of it is rocket science
  • Take your time with the 1st set-up; from the 2nd set-up on it's done in no time
  • If you have any questions, just get in touch. We're here for you!

A few set-up videos (of the 1st prototype)

Set bag with two compartments for the tunnel and the tarp

The idea behind the bag - it has two compartments. The smaller one holds the tunnel (with the suction cups, if you have them). The tarp goes into the large compartment. That way, when setting up, you can quickly attach the tunnel to the vehicle first and only then the tarp.

You can stow the pole bag and the bag with the pegs in the large compartment as well, or make good use of small storage spaces in your vehicle. You can also slide the poles under the bag. That's why the two compression straps of the bag are not sewn down at the bottom.

That's how quick it can be. The side walls can also stay rolled up, and the 3rd pole is only needed in heavy rain.

No keder rail? Every vehicle is different. For the 1st installation, first look for 3 ideal spots on smooth paintwork or glass where you can attach the suction cups. If the side isn't smooth, run the cords over the roof and place the suction cups on the windows on the other side. Only then do you knot the tunnel to the suction cups. Afterwards, leave the suction cups on the tunnel, so from the 2nd time on you can set it up in no time.

Once the tunnel is attached to the vehicle, you can also attach the tarp with the strong zip.

And if you need the vehicle without wanting to take everything down - open the zip, take off the tunnel and off you go (tip: place an object by each tyre. That way you'll quickly find the exact parking position again). Unfortunately, we only filmed this video with 6 poles. Of course it also stands with 4 poles. But you can see that in the other pictures too.

Here's how:

1. Attaching the tunnel to the vehicle

Tunnel being slid into the camper's keder railTunnel in the camper's keder rail

Slide the tunnel into your camper's keder rail.

Suction cup attached with a cord to a loop on the tunnelSuction cup on the camper's roof, cord to the tunnelSuction cup on the camper holding the tunnel by a cord

Alternatively, you can order suction cups along with it, which you connect to the tunnel and attach to smooth paintwork or glass on your vehicle.

2. Connecting the tarp to the tunnel

Tarp being connected to the tunnel with the zipZip between tunnel and tarp

Now use the zip to connect the tunnel to the tarp. For better stability, the zip deliberately has a certain resistance when opening.

Securing the zip puller with the T-pull

To secure the zip, release the loop of the T-pull from the zip puller, pull it through the "buttonhole" in addition to the puller hole, and pull it back over the T-piece to fasten it. This prevents the zip from opening.

Always make sure that the ends of the zip in particular are not under too much tension. Too much tension isn't needed at all and isn't helpful either, as the zip can tear out. If in doubt, after setting up, loosen all tensioners by a few centimetres. That way the tarp has enough play even in strong wind.

3. On to the cords

Step 3: cord on the tarp's loopStep 3: cord on the tarp's loop

To prepare for pitching, pull one cord end each, to which you have knotted the red “tensioner” (see Helpful knots), through the loops where you want to attach the first 2 poles.

Step 3: putting up a poleStep 3: tensioning the cord

Now put up the 2 poles at a slight angle (see Positioning the tarp poles), attach one cord end to the peg, anchor the peg and then tension the cord to the desired tension using the tensioner.

Done already! You've now put up the canopy and can sit back or, as needed, try out further set-up options.

No force needed.

Don't tension the guy lines so tight that you could play guitar on them. The tarp is cut so that it doesn't need to be tensioned excessively for a nice set-up. This takes the strain off the material, and the pegs also have a better chance of doing their job well. Another good tip is to always put the poles up at a slight angle. To re-tension the guy lines, you can also briefly tilt the pole more than usual, re-tension and then put the pole back up.

Set-up variations - be creative

There are countless individual ways to set it up. Thanks to the height-adjustable poles, you can adapt the set-up to your needs and daily conditions at any time. With the 4 poles from the set, you can also set up the tarp freestanding. Below we show you a few practical set-up variations.

Protection from sun, wind and curious neighbours?

You can set up the protection for your outdoor area facing any direction; even when the sun shines from the side or the front, you have shade. To do this, simply tension the side(s) you want down towards the ground.

Set-up variation as sun and privacy screenSet-up variation as sun and privacy screenSet-up variation as sun and privacy screenSet-up variation as sun and privacy screenSet-up variation as sun and privacy screenSet-up variation as sun and privacy screenSet-up variation as sun and privacy screen

Rainy weather?

To stay dry in the rain too and to prevent water pockets from forming, tension the tarp so that it slopes everywhere and the water can't run back towards the zip. This is very important because, although the zip is waterproof, tension pulls the teeth apart and water would get through. The pole with a hole at the top end is meant to be inserted into the cap in the middle of the tarp and secured with the pin (this prevents the pole from falling onto the car in wind).

The hole is deliberately a little tight. This is an extra safeguard to make sure the pole stays in place. Simply insert the pole tip with a bit of pressure and circular movements, or widen the hole slightly with a ballpoint pen before first use.

Rain set-up with centre pole, tarp slopingCentre pole in the cap in the middle of the tarp

When you need to be really quick …

Quickly set up the tarp as a simple canopy.

Tarp as a simple canopy on the camperTarp as a simple canopy on the camper

Little space to set up?

The perfect solution is the gable roof shape. Tensioned wide, you need 3-4 m next to the camper. If space is tight, tension the cords more steeply and angle the poles more – then around 3 m is enough.

Tarp set up as a gable roofTarp set up as a gable roofTarp set up as a gable roof

Large covered area?

The considerable size of the tarp, at just under 20 m², gives you plenty of shade and space outside your camper. Put the sides up horizontally and the party can begin. Dimensions: 3 x 6.5 m.

Tarp with sides put up horizontally as a large covered area

Taking your camper on a trip?

Simply leave the tarp and your camping gear where they are. Open the tunnel's zip, remove the tunnel from your camper, re-tension the tarp if needed and off you go. A good tip - before driving off, mark your tyre position with an object. That way you can get back into the exact position when you return. Before “docking” again, loosen the guy lines a little. Then the zip closes easily without any pulling force.

Freestanding tarp without camper on a mountain meadowFreestanding tarp with four poles, without camperFreestanding tarp with two poles on a meadow

Helpful knots

The bowline - an all-rounder

Knot: cord end on the red tensioner

How do I attach the cord end to the red tensioner?

Knot: cord end on the peg

and the other end to the peg?

Knot: cord between suction cup and tunnelKnot: cord between suction cup and tunnelSuction cup attached with a cord to a loop on the tunnel

and the cord between suction cup and tunnel?

Video: The bowline (YouTube, Yachtschule Overschmidt, in German)

The bowline is a good solution for this.

Tensioning cords

Cord from the guy loop to the red tensioner

How do I tension cords? (before additional tightening with the tensioner)

Video: Topsail sheet bend (YouTube, Survival Kompass, in German)

The guy cord is too long - how can you shorten a cord/rope?

Video: Sheepshank (YouTube, einfachboot, in German)

How do I coil cords up neatly?

Video: Coiling a cord properly (YouTube, I WANNA KNOW, in German)

More tips

Stuff, don't fold

The tarp can simply be stuffed into the duffle bag. Keep the tunnel in the small compartment of the bag - that way it's right at hand when you set up, even in rainy weather.

Positioning the tarp poles

Never put the poles up dead straight. If they stand at a slight angle (ideally opposite to the guy line), they can absorb and divert the forces of the wind better. Vertical poles buckle in the next strong gust. For a stable stand, push the poles into the optimal position and adjust the angle of inclination to the conditions. They don't have to stand vertical to the ground.

Take it down in strong wind

Take the tarp down in gusts from around 50 km/h, especially in sharp, buffeting gusts.

Pitching pegs correctly

Insert the pegs into the ground at a 45-degree angle, with the tip in the ground pointing towards the tarp. Only then can they take the maximum force. If the peg is set too flat, it can break out. If it's too vertical, it can be pulled out of the ground by even a light breeze.

No force

It's often tempting (for us too) to tension the cords and the whole tarp extremely tight. So tight you could play guitar on the guy lines. But that isn't necessary at all, and the material will thank you if it isn't tensioned excessively. It shouldn't flap or sag, but nothing more is needed.

Water flows downhill

Why do house roofs usually have a gable? Because that's how water runs off best. When it rains, tension the tarp so that it slopes everywhere. That way no water pockets form, and you can sit under it even in pouring rain and enjoy the forces of nature.